1. First of all, the self feeding mixer equipment is covered with plastic film, and then the upper side of the film is covered with semi wet towel to prevent high-pressure water from flowing into the distributor, which makes it difficult to start the self feeding mixer.
2. Remove the dirt attached to the engine side and engine side from the top to the bottom of the loading mixer with a high-pressure water gun.
3. After soaking, spray the external cleaner from the feeding mixer directly into the engine and engine room of the mixer.
4. After flashing for 3 minutes, use the fiber brush to clean all accessible parts in the machine room.
5. Use a high-pressure water gun to quickly wash the scrubbed dirt.
6. Then spray the external cleaning agent on the engine surface, and the operation steps are the same as above. Until the surface of the mixer is cleaned repeatedly.
How to clean internal concrete of self loading mixer
When the automatic feeding mixer fails, it is necessary to clean the internal concrete in time.
1. Prepare the emergency drive hose, turn off the agitator, and then remove the high-pressure pipe connector on the hydraulic motor.
2. Remove the high pressure pipe and connect it to the emergency drive hose of the corresponding connector on the faulty vehicle.
3. Start the self loading mixer and set its control handle at the unloading position to discharge the concrete in the truck
4. After the emergency drive is completed, remove the drive hose and restore the vehicle to its original state.
This article is organized and released by Zhongke Jufeng concrete mixer. Do you know something about these contents? For more information, please click: http://www.jufengjiaobanji.com We'll have a lot more to see.