Since the mixer for self feeding of China Science and Technology Corporation is a field car, the model of this kind of car is relatively large, so it is necessary to pay attention to inspection before driving, just in case.
The following points shall be checked before the car is delivered from the charging mixer of China Science and Technology Corporation:
Check carefully and remove the fault in time.
Do not allow heavy vehicles to brake on the road, otherwise there will be failure in case of unevenness. Generally, concrete parking cannot exceed 2 hours, and concrete above C40 level cannot be stopped basically. Check the engine oil, antifreeze, lubricating oil and cooling water before ignition. If deficiencies are found, they should be added again. After the car starts, rotate the can at a low speed to check whether there is any leakage of tire pressure around the car. Use a screwdriver to take out the stone from the joint and check the nails!
Check the lights again, especially the waist lights. Make sure they glow at the edge of the tire. Clean the rear-view mirrors on both sides with rags and windows. In the construction site of complex roads, the light is not good. The line of sight must be guaranteed first!
2. In order to ensure that there is enough water in the water tank, there is a water reducer. Due to various reasons, the material is too dry and there is no water to add and release the material. The water reducer is a life-saving straw.
3. Ensure that the mixing tank is in the stop state, because the mixing tank is in the high-speed rotation state when the engine is started, the instantaneous force will be very large, which will cause damage to the reducer.
4. Whether mixing discharging or discharging mixing, stop at the stop position and move to the next operation position.
The above is the relevant content introduced to you by Zhongke from the charging mixer manufacturer. If you want to know more, please visit the website: http://www.jufengjiaobanji.com