多功能搅拌车底盘进行正确的润滑可以减少汽车零件的磨损，增加搅拌车零件的使用寿命，但是在实施润滑时应注意一下几点：
Proper lubrication of the chassis of the multi-function mixer can reduce the wear of vehicle parts and increase the service life of the mixer parts. However, the following points should be noted when implementing lubrication:
1、正常使用情况下，按搅拌车厂家的保养周期进行润滑，环境恶劣情况下要适当缩短保养周期。
1. Under normal use, lubrication shall be carried out according to the maintenance cycle of the mixer manufacturer, and the maintenance cycle shall be appropriately shortened under harsh conditions.
2、更换发动机机油时，要在热状态时进行，以保证油能放尽。放油时应注意检查机油颜色是否正常、机油有无异物，以便发现故障隐患。待油放尽后，放油螺栓上的异物，然后拧紧。
2. When changing the engine oil, it should be carried out in the hot state to ensure that the oil can be drained. When draining oil, pay attention to check whether the oil color is normal and whether there are foreign matters in the oil, so as to find hidden trouble. After the oil is drained, tighten the foreign matters on the oil drain bolt.

3、要选用规定的润滑油。代用油料须性能接近，主要技术指标须保证，并且用代用油应时常检查，且缩短使用周期。
3. The specified lubricating oil shall be selected. The performance of the substitute oil must be close, the main technical indicators must be guaranteed, and the substitute oil should be checked frequently, and the service cycle should be shortened.
4、换机油滤芯：更换机油时，机油滤清器要同时更换，在密封垫上涂上一层薄薄的油，并且紧固滤清器。
4. Change engine oil filter element: when changing engine oil, the engine oil filter shall be replaced at the same time, a thin layer of oil shall be coated on the sealing gasket, and the filter shall be fastened.
以上就是为大家介绍的有自上料混凝土搅拌罐车厂家的详细的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://www.jufengjiaobanji.com/
The above is a detailed introduction of the manufacturer of self feeding concrete mixing tank truck. I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with professional services http://www.jufengjiaobanji.com/