In the normal operation process of the automatic mortar cement mixer, if the air system often has problems, its operation power will decline linearly, and even can not start normally.
1. The air compressor of automatic mortar cement mixer should be placed horizontally, fixed and ventilated.
2. Can't bear the wind and rain, and can't be exposed to the sun.
3. Adjust the upper and lower limits of the air pressure automatic switch. If the pressure is too low, the cylinder will slow down. If the pressure is too high, the seals of the pneumatic system will be very unfortunate.
4. Check the lubricating oil level of the automatic mortar cement mixing truck, and keep the oil level between the upper and lower lines of the dipstick. When the oil level is near the end of the line, add new oil.
5. Check whether the tension of the conveyor belt is appropriate. When pressing the belt with fingers, the belt should sag about 10 mm. When replacing the conveyor belt, the whole group should be replaced to maintain the common tension.
6. The gas system must be filled with satisfactory oil, and adhere to satisfactory oil quantity and satisfactory normal operation. Only in this way can the power of the front mixer be used together to extend the service life of the gas system.
Today's auto feeding concrete mixer's wonderful content will be shared with you. For more wonderful content, please click our website http://www.jufengjiaobanji.com Leave a message, or call directly, we will have special staff to serve you